SMT & Inspection | February 21, 2007

Europlacer launch new SMT Platform

Europlacer launched its new SMT platform at APEX today.
This new platform called "iineo" features improvements such as a higher feeder count, increased board size and increased maximum component height.

iineo is widely configurable, allowing for 24 different possibilities:

* Single or dual linear motor gantry including a rotary turret head with 8 or 12 pickups
* 1 or 2 board positioning mechanisms
* Oversized board options
* Feeders in front and rear or front only.

The system can accommodate up to 264 x 8 mm tape positions and, in addition to this, an internal waffle tray zone allows for 10 JEDEC trays. iineo also may be equipped with one or two 30-channel waffle tray sequencers.

Depending on the configuration, the following is possible:

* Maximum placement rate can be between 14,000 and 28,000 cph
* The largest PCB can reach 1,500 x 600 mm,
* Component range is from 01005 to 70 x 70 mm
* The tallest component can be 35 mm height.

Possible options include glue dispense with Archimedean screw, electrical test, fixed camera, conveyor auto-width adjustment, special nozzle magazine and more.


Please note the following: Critical comments are allowed and even encouraged. Discussions are welcome. Verbal abuse, insults and racist / homophobic remarks are not. Such comments will be removed.
Further details can be found here.
Load more news
June 15 2018 12:12 am V9.6.1-2