Components | April 10, 2012
Apple craze extends to Lithium Polymer batteries
Effect of Apple craze extends to Lithium Polymer batteries, scale causes price reduction.
Apple’s new iPad has arrived, and its influence on end market and component part product price is gradually taking effect. According to EnergyTrend, green energy research division of TrendForce, market demand for lithium polymer batteries is increasing due to higher power needs, which in turn is causing battery cell unit price to fall. Apple Products to Stimulate Lithium Polymer Battery Demand Significantly The highly anticipated new iPad has finally arrived. It uses the same lithium polymer batteries as its predecessor, but to accommodate the increased power needs of the high-resolution display, 4G data transfer, etc., battery capacity has been upgraded from 2300 mAh to 3800 mAh, a 65% increase. Lithium polymer batteries have always been highly customizable, but because of the wide variation and low volume of early mobile phones, makers were conservative in terms of capacity and supply. However, the improved hardware specification that has come with the popularity of Apple’s iPad, as well as the elevated power requirements of tablet PCs and smartphones, will benefit lithium polymer battery demand. As for system design, the new iPad’s battery still consists of a one in series, three in parallel (1s3p) configuration,so there is little difference in the battery protection board. Battery pack yield rate will face a bit of a challenge, but overall the product trend is a boon to battery makers. Large Lithium Polymer Battery Demand on the Rise Led by Apple, demand for large lithium polymer batteries has soared in applications from new tablet PCs to ultrabooks. In terms of the manufacturing process, there are no significant differences between large and small lithium polymer batteries – the yield rate difficulties caused by the thinner form factor is still the main issue. However, according to EnergyTrend, currently manufacturers have not yet hit a bottleneck in terms of production capacity. Looking at Q2 2012 supply and demand, based on scheduled arrivals of new tablet PC and ultrabook models, demand will increase significantly. This will in turn raise the capacity utilization rate for battery product lines, and large lithium polymer batteries will begin to see significant price reductions. Furthermore, according to EnergyTrend research, as many new products from manufacturers are still in the initial stages, there is enough capacity to meet demand. Thus, demand-induced price reductions are unlikely in the short term, but in the future when capacity increases, to the point that supply is tight, the industry will see price reductions – the situation will become clearer after Q2 2012.
Cree, ABB form partnership for SiC technology Silicon carbide technology specialist Cree and ABB’s Power Grids business have announced a partnership to jointly expand the rollout of silicon carbide for semiconductors.
Soitec & Applied Materials to develop next-gen SiC substrates Designer and manufacturer of semiconductor materials, Soitec, is entering a joint development program with Applied Materials on next-generation silicon carbide substrates.
Swissbit to stay on top of demand with new Berlin fab Back in late July of 2018, Swissbit AG, broke ground on its new R&D and manufacturing facility in Berlin with the aim of tripling the production capacity of location. Now its already up and running.
Nuvia closes series A, eyes data center servers Santa Clara semiconductor design startup Nuvia Inc., formed earlier this year by three former top Apple Inc. design executives, has closed its series A round with USD 53 million secured.
Sponsored content by EsemdaContract manufacturer Esemda opens new facility in Vilnius and expands EMS The new facility has been built with reserved space for future expansions. As Esemda constantly grows, it is of great importance to be able to rapidly increase production capacity in large volumes.
Ingun's going global; expands in Latin America and Eastern Europe Benjamin Sontag (INGUN Prüfmittel GmbH) gave a short update on expansion plans in Latin America and Eastern Europe.
Yageo to acquire KEMET in a $1.8 billion deal Yageo Corporation and KEMET Corporation have entered into a definitive agreement under which Yageo will acquire all of the outstanding shares of KEMET’s common stock for USD 27.20 per share in an all-cash transaction valued at USD 1.8 billion.
EVG and DELO partner to expand materials and process capabilities Supplier of wafer bonding and lithography equipment for the MEMS and semiconductor industry, EV Group (eVG), is partnering with DELO, a manufacturer of industrial high-tech adhesives, in the area of wafer-level optics.
Osram recommends current takeover offer from ams Osram says it has concluded a business combination with Austrian chipmaker ams and is recommending its shareholders to accept the current takeover offer.
Sponsored content by Z ElektronikaZ Elektronika opens new factory in Pécs To keep up with rapid growth of the company, on the 13th September Z Elektronika celebrated the grand opening of its new electronic design and manufacturing facility close to the highway in Pécs, Hungary, which adds new features and production site to its nearby location.
EpiWorld speeds up commercialisation of SiC devices with AIXTRON AIXTRON SE has provided an AIX G5 WW C system to EpiWorld International Co., Ltd for the further development of next generation silicon carbide (SiC) epitaxial wafers mainly used for the manufacturing of power devices for automotive applications.
FlexEnable makes acquisition for flex displays FlexEnable, developer of flexible organic electronics, has purchased Merck's portfolio of high-performance organic thin-film transistor (OTFT) materials.
Sponsored content by SourcengineComponent Aggregators vs E-Commerce Marketplaces What is the difference between electronic component aggregators and a marketplace?
67% of a buyer’s journey is now done digitally. Learn how marketplaces emerged as full-cycle procurement platforms and challenged the traditional component aggregators.
Samsung’s CPU project ends, layoffs in CA and TX Samsung has confirmed in a letter to the Texas Workforce Commission that layoffs as a result of the closure of the CPU project at the Samsung R&D Center (SARC) in Austin, Texas and the San Jose Advanced Computing Lab (ACL) in San Jose, California, will begin December 31.
Marvell completes acquisition of Avera Semi Marvell has completed its acquisition of Avera Semiconductor, the Application Specific Integrated Circuit (ASIC) business of GlobalFoundries.
IAR Systems opens office in Taiwan Swedish IAR Systems, a supplier of software tools and services for embedded development, says the company is expanding in Asia with the opening of an office in Taipei, Taiwan.
ZF and Cree partners up to advance the electric drive ZF Friedrichshafen is teaming up with silicon carbide semiconductor specialist Cree, to create industry-leading, highly efficient electric drivelines.
Broadcom completes acquisition of Symantec Enterprise Security business Semiconductor company Broadcom, says that the company has completed its acquisition of the Enterprise Security business of Symantec Corporation
AVX acquires Chengdu OK New Energy AVX Corporation says it has completed the purchase of Chengdu OK New Energy, Ltd. (COKNE).
Vesper names new SVP of worldwide sales & business development MEMS sensor company Vesper, announces that Lorenzo Ponzanelli has joined the company as senior vice president of worldwide sales and business development, overseeing sales strategy and execution to drive global growth.
Gigaphoton establishes new company in China Gigaphoton, a manufacturer of light sources used in semiconductor lithography, says it has established and started running the business of a new company – Gigaphoton China Inc. in China.
Prepare, adapt & overcome - how ‘to Brexit’ The looming, but yet unknown, effects of Brexit have forced companies to prepare for whatever may come. But how does one really prepare for unknown consequences?
Acal BFi signs pan-European agreement with Champs Technologies Acal BFi says it has added Champs Technologies to its magnetics portfolio. Acal BFi is a Europe-wide specialist technology supplier and design partner with a specialist portfolio of magnetic cores and inductive components products and services.
POET’s sale of DenseLight Semi to close POET Technologies Inc. announced the sale of its subsidiary, DenseLight Semiconductors Pte. Ltd. to DenseLight Semiconductor Technology (Shanghai) Co. Ltd. is scheduled to close on or before Friday, November 8, 2019.
Odyssey Semiconductor picks up wafer fab Ithaca, New York’s Odyssey Semiconductor Technologies, specializing in high-voltage power switching components and systems based on proprietary gallium nitride (GaN) processing technology, has acquired an integrated semiconductor design, fabrication, test, and packaging facility.Load more news